Job Color Replacement for Prorip/iColor

Job Color Replacement for Prorip/iColor

Ryan Hallahan

In pro rip if you right click on the design you want to print and go to job color replacement; you can then adjust the colors manually in there. All you have to do is click on the specific color you want to adjust and change the output values. Then you press add and apply and it should change the color. You then would have to right click on the design again and press RIP only and then you click view raw data. Also, to get the values for the specific color you want to do all you have to do is go to the built-in test prints and select the CMYK swatches. That will show you all the values for specific colors. This video link gives a visual representation of what was just explained

https://www.loom.com/share/526408115b1b4b6c9acaae6c4b737fa4In

 

Leave a comment

Please note, comments must be approved before they are published