FreeJet 330TX Capping Top Sponge for Maintenance Station.
When your capping top sponge in your FreeJet garment printer starts to look nasty....replace the capping top instead of the whole station
To Fix: There is only one spring (on the right). You basically detach the spring, slightly push down on the back side to release the black pin and lift up. Then you detach the four ink tubes and it comes right out. Then you simply reverse the steps.
When replacing the capping top, you may lose the spring that holds the capping top on to the pump and capping station. This is a separate part and does not come with the capping top. Use our DTG Technical Tool Set to get the spring on and off.
First disconnect the spring from the capping top
Make sure you have the tubes in the correct valve before securing it down
Push the capping top into position and secure using the DTG Technical Tools to pull the spring onto the clip