SWF Embroidery Repair Articles

LCD Controller Abbreviated Instructions SWF LCD Abbreviated Instructions (v2.10) (For most common operations)Read a Design from Disk 1. Insert the...

I hit a hoop while sewing, now what? Reasons and Solutions There are several things to check after a hoop...

How do I LOAD a design on the standard control panel? Insert the design disk into the floppy disk drive....

The movable cutter, located in the bobbin area, might not be returning completely I had the same problem and it...

To move stitches forward on a SWF (single-head, multi-needle embroidery) machine, you will need to adjust the machine's settings. Here...

I bought a SWF 601C. I've had it for a couple of months and it has worked great. yesterday i...

Offset Programming for Appliqué (For SWF LCD Type Controller) The following is a quick start guide for programming and executing...

What is the recommended OILING PROCEDURE? Reasons and Solutions: Oiling is essential for every machine to function properly and to...

Do you have problems with oil dripping on your clothing, or oil showing up on your presser feet? I usually...

Needle bar in down position on every needle It sounds like your jump motor needs to be adjusted or replaced....

Download the Reciprocator Replacement Instructions PDF  Replacing the Reciprocator on an SWF Multi-head. Follow the instructions below to replace the...

Reasons and Solutions The Emergency Stop Button stops the machine at the exact moment the button is pressed. *The machine...

Problem: Needle was coming unthreaded at the beginning of every letter. (Oddly, designs stitched perfectly, larger fonts stitched perfectly, only...

My B-T1501 stopped trimming the threads this morning and I have not been able to find the cause. The blade...

Question: How do I increase the satin width on a design? Answer: Using the STANDARD Controller: Load the design as...