EMC 10 THE THREAD PULLS OUT OF NEEDLE
Osman Bayrak
THE COLORED THREAD PULLS OUT OF THE NEEDLE AFTER A TRIM CAUSING A THREAD BREAK:
- This error is caused by all of the information mentioned in the section before. Use the suggested tips to try to solve this problem.
- Check the Under Thread Presser as seen in the Technical Manual. Replace the part if the profile of the part is the same as the damaged one shown in the figure. Call your distributor for a replacement.
- Make sure the Velcro that the that the Grabber pulls the thread through isn't worn or torn away from it's mounts.
- Make sure the Grabber is moving, and catching the thread at a trim cycle.
- Check the Picker at a normal trim cycle or trim immediate to see if it is moving.
- Check the tails that are trimmed to see if the cut is frayed or a clean cut.
- If the tail is frayed, check the cutting ability of the Spring Knife as shown in the Technical Manual (Trimmer Option Section) to see if the blade is cutting properly. Replace the Spring Knife, and Movable Knife if the cut is still frayed during the test. Call your distributor to order parts.
- Call your distributor for a service call if the error continues.