DTG Kiosk Support

To reset the Waste Ink Counter using this switch (letÙs call it the Waste Ink Reset Switch), please follow this procedure: Ensure that the printer is in the Loaded position (press LOAD) Turn the Power off at the control panel of the printer, leave the printer connected to mains power    Press and hold the Error Eject and Reset Switch, and while holding them, turn on the power. The Error Eject Light and seven ink lights will start to flash.  Release the Error Eject button and Reset Switch, and then quickly press & hold only the Reset Switch again for over 10 seconds. The Error Eject Light, Power Light and seven Ink lights will turn on for two seconds. Once the printer starts going through itÙs normal initialization sequence, you can release the Reset Switch   The Waste Ink Counter has now been reset. Download the  DTG Kiosk II Waste Tank Reset PDF

Monthly Change waste pad on opposite side from print head - this can be turned over for longer life  Oil print head carriage rail Flush white ink lines with distilled water and refill  Consolidate white ink and thoroughly clean bulk ink bottles and replace in bulk system Any and all of the above should also be done "as needed"

Weekly Clean the wiper with cleaning solution or window cleaning fluid and cotton swab or paper towel  Clean capping station - pay special attention to cotton fibers around the edges of the cap area can be done with cotton swab, paper towel or soft cloth (again - use cleaning solution or window cleaning solution)  Inspect waste pad - replace or turn over if needed  Inspect encoder strip & clean as needed (be sure to clean from control panel side towards opposite side)  Fill capping station with cleaning solution or window cleaning liquid and press INK FILL button to empty  Clean inside of bed (especially sides) with window cleaning solution and paper towel

Daily Inspect printer to make sure there are no foreign objects that will interfere with head or bed movements Clean print head assembly with damp cloth (can use window cleaning solution and paper towels) - DO NOT WIPE BOTTOM OF PRINT HEAD ASSEMBLY - DAB IT ONLY Top off ink bottles (especially white) Run 2-3 head cleanings from the control panel Check remote waste ink tank - empty and replace if needed  Run nozzle check from Epson 2200 driver - perform head cleanings if needed