Using the Universal Table on the Melco G3


Tools needed for installation:

  • 2.5mm Metric Hex Driver
  • 3mm Metric Hex Driver

Needed Parts:

  • T-Shirt Table, Universal
  • Four (4) M4 Countersunk Hex Screws

universal table parts

Installation Instructions

  1. Remove the Standard Frame Table from the machine.
    1. Loosen and remove the hardware – 4 screws – at each corner of the table using the 3mm Metric Hex Driver.

      standard table screws

    2. Remove the Standard Frame Table and store it in a secure location.
  2. Remove the Rear Long Table Interface Bracket using the 2.5mm Metric Hex Driver.

    interface brackets

  3. Leave the Front Long Table Interface Bracket in place as is.

    front bracket

  4. Mount the Rear Long Table Interface Bracket you removed in step 2 above in the location shown below using two (2) M4 Countersunk Hex Screws.

    back bracket moved forward

  5. Align the Universal T-Shirt Table as shown in the picture below and secure it to the Table Support using four (4) M4 Countersunk Hex Screws.

    universal table

Buy parts for your Melco G3

Leave a comment