EMC 10 EPBIOS UNIT NUMBER FLASHING

Osman Bayrak

THE DISPLAY IS FLASHING EPBIOS UNIT NUMBER AND THE EMC 10 WILL NOT COME ON LINE:

  1. EDS II or III has to be booted at the computer for the machine to come on line.
  2. Must send a design for the machine to come on line.
  3. Enable a second machine to make sure EDS is scanning for peripherals.
  4. Refer to page 10-3 in the EDS2 manual and page 11-2 in the EDS3 manual, for instructions on how to use the Disable and Enable function.
  5. Reconfiguring the machine is a good practice for proper function with EDS and the RSA files. Refer to the Operation Manual in the table of contents and see: "Configuring the EMC10"
  6. Check the computer to peripheral Interface Cable, making sure that it is connected and not damaged at both ends.
  7. Interface Cables are available in various lengths call your distributor for part numbers. The total length shouldn't exceed 200 feet for all peripherals in the network.
  8. Perform the 5Volt Test according to the information in the technical manual: Power Supply (5Volt Setting)
  9. The CPU PCB may be defective in the machine. Call your distributor to order the CPU PCB. Refer to the Technical Manual for replacement instructions.
  10. The Computer Network Board may be improperly configured or damaged. Check EDS for proper configuration and set up.
  11. If still not coming on line, call your distributor for a service call.