How to Find and Resolve Toner Sensor Errors: IColor 500, 600 and 700
Paul Boody
If your printer displays a toner sensor error please check the following:
Please perform the following instructions if you receive one of the following error codes:
- Toner Sensor Error, Color: Yellow
- Toner Sensor Error, Color: Magenta
- Toner Sensor Error, Color: Cyan
- Toner Sensor Error, Color: Black
The printer has four slots for four image drums; Cyan, Magenta, Yellow and Black, or Cyan, Magenta, Yellow and White.
How do I find the Toner Sensors?
Press the cover release and open the top cover fully and note the positions of the four cartridges:
There are two sensors for each toner: one on the drum (TS1) and one on the machine (TS2).
TS1: The toner sensor is located on the right hand side of the drum.
TS2: The toner sensor on the machine can be found on the right hand side panel of the machine on the inside (see image below).
The sensor is located in an oval shaped hole, this works in conjunction with the toner sensor located on the right hand side of the drum.
Toner Sensor Errors
A toner sensor error is displayed when the machine is no longer able to detect the toner cartridge / drum unit, or is no longer able to determine how much toner is left in the units.
How to clear the Toner Sensor Errors?
If your printer displays a toner sensor error please power off the printer and check the following:
- Check that all the blue toner levers are pushed firmly towards the back of the machine. Remove and replace the toner cartridge into the drum unit.
- Check if the sensors need to be cleaned. The sensor is located behind a plastic cover on the side of the drum (see below). Remove the plastic cover and give the silver arm a clean with something small and soft (lint free), any toner that has built up on the sensor will be a very fine powder and should easily be removed.
Check if the sensor lever on TS1 has been pushed up. Once you have cleaned the arm, check that the sensor lever has been pushed up (see correct position below).
If it is incorrect it can sometimes lead to the blanking disc not being pulled out of the way, which results to the sensor on the machine not picking up the sensor on the drum. Pushing the disc up will resolve the problem. The disc will not fall back down again, providing that the blue Toner Lever is pushed firmly to the back of the machine.
After all the checks are completed place the cover back on the side of the drum. It should go back in the same way it came off. If you are unable to fit the plastic cover back on the drum, you can leave it off as it will not interfere with printing.
Install the drum and toner in the machine and power it on.