Anajet Sprint Print Head Replacement


Get a Replacement print head for your Anajet FP-125 to repair your Anajet sprint

Caution: The Print head is very static sensitive, use antistatic protective equiment when working on it.

 Before beginning this repair make sure the power is turned off at the back switch and the printer’s power cord is unplugged.

1 - Remove the Dampers [See Damper replacement]. To avoid ink leaking, place Dampers and Ink Tubes higher than the level of the Ink Cartridge.

Anajet SPrint Print Head Repair


2 - Release the Print Head Carriage and move it away from the right side of the chassis, see User Manual page.

3 - Remove the Flat Flex Cable (FFC) Guide from the Print Head Carriage by releasing the upper tab and then rotating the guide forward.

Anajet SPrint Print Head Repair


 Anajet SPrint Print Head remove

4 - Remove the three M2.6 X 8 screws securing the Print Head. Lift the Print Head straight up to remove.

Anajet SPrint Print Head fix

5 - Disconnect the two FFC from the removed Print Head. Make sure to keep them in the same order by replacing them one at a time.




6 - Check to make sure the Foam Pad is attached to the end of the Print Head.

Anajet SPrint Print Head remove

7 - Check that the Foam Dam is properly positioned on the right guide pin.

Anajet Sprint Print Head problem

8 - Reassemble the Print Head by reversing the removal steps. When reinstalling the screws, use care to re-enter the same thread originally formed in the plastic carriage. While tightening the screws press the Print Head toward the rear of the unit. Tighten the screws in the order shown in the photo below . Tighten the screws to 10 to 15 N cm (14 to 21 in ozf).

 Anajet SPrint Print Head Repair fixing

9 - Reassemble the Dampers and Damper Retainer.

 Anajet SPrint Print Head troubleshooting

10 - Before powering up the printer, make sure the Print Head is all the way to the left, then perform an Ink Charge and check for nozzle performance.


Get a Replacement print head for your Anajet FP-125 to repair your Anajet sprint

 epson r1900 printhead


Leave a comment

Please note, comments must be approved before they are published