DTG HM1, HM1-C Capping Top Sponge

In stock
SKU
DTGhm1cap
$24.95

DTG Capping Top Sponge for Maintenance Station.  

Compatible:

  • DTG HM1
  • DTG HM1-C

 When your capping top sponge in your DTG garment printer starts to look nasty....replace the capping top instead of the whole station

dirty capping top

 

To Fix:  There is only one spring (on the right).  You basically detach the spring, slightly push down on the back side to release the black pin and lift up.  Then you detach the four ink tubes and it comes right out.  Then you simply reverse the steps.

When replacing the capping top, you may lose the spring that holds the capping top on to the pump and capping station.  This is a separate part and does not come with the capping top.  Use our DTG Technical Tool Set to get the spring on and off.

First disconnect the spring from the capping top

remove capping top spring

 

Make sure you have the tubes in the correct valve before securing it down

capping top hose configuration

Push the capping top into position and secure using the DTG Technical Tools to pull the spring onto the clip

There are no reviews yet Be the first to review this product
You're reviewing: DTG HM1, HM1-C Capping Top Sponge as
Your Rating

Ask a question about this product
Enter your information and we will respond as quickly as possible!
We found other products you might like!
All your garment printing ink, parts, supplies, heat transfer vinyl, vinyl cutters, white toner transfer printers and transfer paper in one place