DTG HM1, HM1-C Capping Top Sponge

DTG SKU: DTGhm1cap

$24.95

DTG Capping Top Sponge for Maintenance Station.

Compatible:

  • DTG HM1
  • DTG HM1-C

When your capping top sponge in your DTG garment printer starts to look nasty....replace the capping top instead of the whole station

dirty capping top

To Fix: There is only one spring (on the right). You basically detach the spring, slightly push down on the back side to release the black pin and lift up. Then you detach the four ink tubes and it comes right out. Then you simply reverse the steps.

When replacing the capping top, you may lose the spring that holds the capping top on to the pump and capping station. This is a separate part and does not come with the capping top. Use our DTG Technical Tool Set to get the spring on and off.

First disconnect the spring from the capping top

remove capping top spring

Make sure you have the tubes in the correct valve before securing it down

capping top hose configuration

Push the capping top into position and secure using the DTG Technical Tools to pull the spring onto the clip

Instructions for the DTG HM1, HM1-C Capping Top Sponge

No additional instructions found for this product.

We're here to assist you with all your garment printing needs. Reach out to our dedicated team during our office hours, and we'll ensure you get the support you need.

Office Hours

Monday to Friday: 9:00 AM - 5:00 PM

Contact Methods

For general inquiries, you can contact us through the following:

Address: 375 Oser Ave, Hauppauge, NY 11788