Once the print job has completed the table will move out to the load position providing you with access to...
Search
Search for products, pages, or blog posts
Melco G2 Support
Melco G2 Sleeve Table
Tools needed for installation: 2.5mm Metric Hex Driver 3mm Metric Hex Driver Needed Parts: Sleeve Table Adapter Plate Two (2)...
Melco G2 Small Table
Tools needed for installation: 2.5mm Metric Hex Driver 3mm Metric Hex Driver Needed Parts: Small Table Adapter Plate Two (2)...
Melco G2 Polo Table
Tools needed for installation: 2.5mm Metric Hex Driver 3mm Metric Hex Driver Needed Parts: Polo Table Four (4) M4 Countersunk...
Melco G2 Large Table
Tools needed for installation: 2.5mm Metric Hex Driver 3mm Metric Hex Driver Needed Parts: T-Shirt Table, Large Four (4) M4...
Melco G2 Universal Table
Tools needed for installation: 2.5mm Metric Hex Driver 3mm Metric Hex Driver Needed Parts: T-Shirt Table, Universal Four (4) M4...
Troubleshooting the Melco G2 Garment Printer
With all troubleshooting it is critical to test in a controlled environment. A controlled environment is one where you start...
Melco G2 - Error Codes
Melco G2 - Error Codes Error Code Explanation Answer 01001D This can occur during machine initialization but may occur during...
Melco G2 Ink Cartridge Maintenance and Resetting the Chip
Guidelines for Storage and Handling of Inks Shake ink cartridges each day before use to ensure the best possible printing...
Cleaning the Encoder Strip on the Melco G2
The Linear Encoder Strip is a clear film that is etched with a many vertical lines that are read by...
Cleaning Solution Cartridges Melco G2
Cleaning solution cartridges are used when the machine is to be prepared for storage or for purging the Ink Delivery...
Cleaning the Flushing Box on the Melco G2
Waste ink and cleaning solution are deposited into the Flushing Box which then drains into the Waste Ink Tank to...
Cleaning the Wiper on the Melco G2
The Wiper acts as a squeegee cleaning the bottom of the Print Head and Nozzles as it passes over the...
Cleaning the Capping Station on the Melco G2
Capping Station maintenance should be completed at the end of each use of the printer daily (if printing daily). Pour...
Cleaning the Waste Ink Tank Melco G2
The Waste Ink Tank holds ink and cleaning solution that has been purged from the Ink Delivery System during cleaning...
Melco G2 Maintenance Schedule
Once properly set up, the MelcoJet G2 can be left in an "idle" state for 7-10 days. Idle meaning, the...
