Buy the capping station for the DTG M2 and M4 Garment Printer Here!
Buy parts for the DTG M2 and M4 Garment Printer Here!
5.2.3 Removing the Pump/ Cap Assembly

- Switch the Printer OFF.
- Carry out the head park procedure.

- Remove the allen screw as shown then remove the CR Lock Detent Cover.
- Slide the cover towards the front of the printer and lift the cover up and off.
- Remove the two cross point screws retaining the waste flushing unit.
- Remove the waste flushing unit.
- Locate the pump motor wiring harness (to the rear & below the carriage rail) as shown below.
- Carefully unplug the pump harness from the cable connector.
- Remove the two rear retaining cross point screws (below rear of carriage rail) as shown.
- Next remove the two front retaining cross point screws.
- Gently lift the pump cap assembly out by lifting the front portion up and out.
- Rotate the assembly anti-clock wise to access the pump phase sensor connector.
- Disconnect the pump phase sensor connector from the pump assembly.
- Carefully lift the pump cap assembly out of the printer.
- The waste drain can now be cleaned out.
- The pump cap assembly is shown here in the lower right picture.






