Removing the Control Panel on the Brother GT-541


7-3. Disassembling the Control Panel

Article 12 Picture 1

(1) Rotate the Print Button Cover counterclockwise to remove it.

Article 12 Picture 2

(2) Remove the four screws truss (M4x6) (shown in the picture below), and then remove the Control Panel.

Article 12 Picture 3

(3) Turn over the Control Panel, and then disconnect the Flat Cable from the Pancel PCB.

  • The Flat Cable connector on the Panel PCB can be unlocked by pulling the connector tab to the Flat Cable side.

(4) Disconnect the Print Button harness connector from the Panel PCB.

Article 12 Picture 4

Buy the Brother GT-541 Control Panel

Leave a comment

Please note, comments must be approved before they are published