Check Ink Cartridges
Check printer control panel for EMPTY messages, pull out ink cartridges to double ensure you have ink in the cartridges or replace as needed.Shake white cartridges for at least 10 seconds; have the valve facing upward and away from your body in case of a valve failure.Circulate both white ink lines between 5 to 10 minutes
Check print head voltages
Calibrate if necessary
Check right side spit pad
Empty & replace if completely saturated
Check Wiper Blade Clean and remove build up of ink on the blade itself.
Check that the wiper blade is moving into place. If wiper is not moving, go to wiper blade function within maintenance menu. Engage wiper blade and physically give it a nudge. You may need to clean any buildup of ink getting in the way.
Check Maintenance Station
Gently remove residual ink around each of the ink cups. This will ensure a proper seal with the print head
Check Nozzle Plate
Release print head carriage and lower print table to help view nozzle plate. You can also use a mirror to view nozzle plate. Remove ink buildup with lint free wipes and alcohol.
Perform Nozzle Check
Do a Light Cleaning and print a nozzle check, you may repeat it couple times. If poor nozzle check, see Troubleshooting guide
General cleanliness of printer
Clean the Carriage Plate. Release the carriage and lower the printing table. Use a mirror to inspect the carriage condition. With a lint-free wipe and 90% isopropyl alcohol, clean the aluminum part of the plate, do not smear the dry ink into the heads plates.
Clean the maintenance station
Clean the sealing cups of the maintenance station, pay extra attention to the white cups, all of them should look as a normal black rubber. Clean the wiper blade, pay attention to the top portion of the wiper; it should be dry ink free mainly on the angled top part. If wiper blade is removed, make sure the angle of the blade is facing the maintenance station suction caps.
Clean Left Spit Pad
Remove Philips screws (2) located under the capping station. Clean or replace pad as it becomes saturated.
Perform Maintenance Station Flush and Clean
Turn on maintenance station pump. With a syringe, pour cleaning fluid into each of the 6 cups while the pump is running. This will clean capping station and ink reservoirs. Gently clean gaskets. Clean wiper blade. Clean nozzle plate with lint free wipes.
Lubricate wiper slider arm and move wiper back and forth to exercise.
Empty Waste Tank
Dispose of waste properly.
Clean the encoder strip
Shake White Ink Cartridges and Circulate
Shake white cartridges for at least 15 seconds; have the valve facing upward and away from your body in case of a valve failure.Circulate both white ink lines between 15 to 20 minutes