Removing the Control Box on the Brother GT-541

Print Friendly, PDF & Email

6-2-7. Replacing Control Box

When the PCBs inside are replaced, use GTService Tool to readjust firmware controls. Prepare a voltmeter (tester) and a thermometer and refer to the pages concerned.

(1) Remove Power code.

Article 14 Pic 1

(2) Remove Operation Panel.

     Remove 4 screws at both sides.

Article 14 Pic 2

Unscrew the Print SW counterclockwise. Do not miss the black rubber ring inside.

Article 14 Pic 3

Disconnect FFC Harness of CN4:PANEL and CN2:PRT SW and remove Operation Panel.

Article 14 Pic 4

Confirm the direction of insertion and the lock/unlock mechanism.

Article 14 Pic 5

(3) Remove covers.

     Unscrew 2 screw of CF cover.

Article 14 Pic 6

Remove Frame Front Cover. (Remove 3 rubber caps and unscrew 7 screws.)

Article 14 Pic 7

Unscrew 6 screws and remove Frame Cover (Right).

Article 14 Pic 8

(4) Remove Box cover.

      Unscrew 4 screws.

Article 14 Pic 9

Remove the clamp and pull out the cover.

Article 14 Pic 10

<Note>
Do not soil FFC connectors with grease nor damage. Do not touch connectors with bare hands.

(5) Disconnect Harnesses on Main PCB.

      Disconnect Harness CN4: CR MOT&JAM

Article 14 Pic 11

Get ink and parts for your Brother GT541 Garment Printer